[DXLog.net - Support] Failure CAT
EC7AKV Alfonso
ec7akv at gmail.com
Wed Oct 2 00:22:36 CEST 2013
Bob.. nothing now no conected with any configuration.
Omnirig in 706, 706MKII, 706MKKIIG with Dxlog in 706, 706MKII and 706MKIIG and Omnirig, and no conected, all software is closed, only have open DXLog, ports is closed, is i have good luck, conected but when i only moved 1Khz with dial... closed the CAT, Uninstall, Install, reinstall, and all softwares have CAT but DXLog no conected.
any idea?
--------------------------------------------------------------------------------------------------------
J. Alfonso Navas - EC7AKV (AkA ED7T - EF7T)
Correo E-mail ec7akv at gmail.com
Tlf: 655.075.252
Cláusula de Confidencialidad: Este mensaje, y en su caso, cualquier fichero anexo al mismo, puede contener información confidencial o legalmente protegida (LOPD 15/1999 de 13 de Diciembre), siendo para uso exclusivo del destinatario. No hay renuncia a la confidencialidad o secreto profesional por cualquier transmisión defectuosa o errónea, y queda expresamente prohibida su divulgación, copia o distribución a terceros sin la autorización expresa del remitente. Si ha recibido este mensaje por error, se ruega lo notifique al remitente enviando un mensaje al correo electrónico ec7akv at gmail.com y proceda inmediatamente al borrado del mensaje original y de todas sus copias.
Gracias por su colaboración.
Siempre mirando por el Medio Ambiente, NO imprima este correo si no es necesario.
NOTA: Los acentos han sido omitidos de forma intencionada.
----- Original Message -----
From: Bob Wilson, N6TV
To: DXLog.net Reflector
Sent: Saturday, September 28, 2013 1:45 AM
Subject: Re: [DXLog.net - Support] Failure CAT
2013/9/27 EC7AKV Alfonso <ec7akv at gmail.com>
> Nothing with Omnirig, without Omnirig. Configure CAT... all is OK, move
> the dial up, move down and... close the CAT, y restart the CAT, and... move
> down, move up and little time, close de CAT.
First you have to Configure OmniRig:
1. Close DXLog.net
2. Start -> All Programs -> Omni-Rig -> Omni-Rig
3. Set up the COM port and baud rate
4. Close Omni-Rig
5. Open DXLog.net
6. SETUP [Enter]
7. Set the same COM port to Radio 1 (COM1), Radio Type: OmniRig instead
of IC-706
But, you can't use COM1 to control Radio 1 by OmniRig / DXLog.net and tell
MMTTY to use COM1 for PTT at the same time. Only one program can use COM1
at a time. Maybe put the radio's RS-232 line on COM1 and FSK/PTT on COM2?
73,
Bob, N6TV
_______________________________________________
Support mailing list
Support at dxlog.net
http://www.dxlog.net/mailman/listinfo/support
More information about the Support
mailing list