[DXLog.net - Support] DXLog MMVARI not transmitting

Bob Wilson, N6TV n6tv at arrl.net
Thu Sep 26 00:35:51 CEST 2013


In MMVARI, Option | Setup.  In the TX tab, did you set PTT to anything or
does it say "NONE"?  Maybe you need to make MMVARI control PTT rather than
DXLog.net.

73,
Bob, N6TV

On Wed, Sep 25, 2013 at 3:06 PM, David Ross <drossm at sympatico.ca> wrote:

> Had the settings correct except for the Baud, was 9600 and now 4800 and I
> now have CAT control but still not transmitting in MMVARI.
>
> David  VA3MJR
>
>
>
> > From: n6tv at arrl.net
> > Date: Wed, 25 Sep 2013 14:35:30 -0700
> > To: support at dxlog.net
> > Subject: Re: [DXLog.net - Support] DXLog MMVARI not transmitting
> >
> > On Wed, Sep 25, 2013 at 11:25 AM, David Ross <drossm at sympatico.ca>
> wrote:
> >
> > >
> > > DXLog is still not reading either VFO frequencies
> > >
> >
> > David,
> >
> > What have you tried to do so far?  Did you look at menu 027 to see what
> > baud rate your radio is using?  Default is 4800.  I suggest setting menu
> > 029 (CAT RTS) to OFF.  Then just set up the radio's COM port in DXLog.net
> > to the same values:  4800,N,8,2, Always OFF, Always OFF.
> >
> > 73,
> > Bob, N6TV
> > _______________________________________________
> > Support mailing list
> > Support at dxlog.net
> > http://www.dxlog.net/mailman/listinfo/support
>
> _______________________________________________
> Support mailing list
> Support at dxlog.net
> http://www.dxlog.net/mailman/listinfo/support
>


More information about the Support mailing list