[DXLog.net - Support] Failure CAT

[Bob Wilson, N6TV]

2013/9/27 EC7AKV Alfonso <ec7akv at gmail.com>

> Nothing with Omnirig, without Omnirig. Configure CAT... all is OK, move
> the dial up, move down and... close the CAT, y restart the CAT, and... move
> down, move up and little time, close de CAT.


First you have to Configure OmniRig:

   1. Close DXLog.net
   2. Start -> All Programs -> Omni-Rig -> Omni-Rig
   3. Set up the COM port and baud rate
   4. Close Omni-Rig
   5. Open DXLog.net
   6. SETUP [Enter]
   7. Set the same COM port to Radio 1 (COM1), Radio Type:  OmniRig instead
   of IC-706

But, you can't use COM1 to control Radio 1 by OmniRig / DXLog.net and tell
MMTTY to use COM1 for PTT at the same time.  Only one program can use COM1
at a time.  Maybe put the radio's RS-232 line on COM1 and FSK/PTT on COM2?

73,
Bob, N6TV