[DXLog.net - Support] Footswitch
Souzkabel
souzkabel at yandex.ru
Mon May 19 09:34:47 CEST 2014
Hello Chris !
Thank you very much
I tried to do the same
I probably made a mistake
I will try again and again :)
Vlad
R9IR
From: 9A5K [mailto:9a5k at 9a5k.com]
Sent: Monday, May 19, 2014 2:05 PM
To: SOUZKABEL
Cc: support at dxlog.net
Subject: Re: [DXLog.net - Support] Footswitch
Hi Vlad..
It is same as used with N1MM software..
So, here it goes:
Serial port footswitch information (using the 9 pin connector numbers)
Connect a 10k resistor between pin 6 and pin 7. Set DTR, pin 4 to "Always On" and RTS, pin 7 to "Always Off". Connect the footswitch between pins 4 and pin 6.
The program action will be on footswitch closure. The footswitch wires can not be referenced or connected to ground.
This is how I am using it too here. And works.
Of course, you need PTT pin configure on some of the interfaces..
73,
Chris - 9A5K
On Mon, May 19, 2014 at 3:24 AM, SOUZKABEL <souzkabel at yandex.ru> wrote:
Hello !
Specify how to make the interface and the settings for connecting to the serial port footswitch. ?
This feature is already working?
My attempts were unsuccessful :(
R9IR
Vlad
_______________________________________________
Support mailing list
Support at dxlog.net
http://www.dxlog.net/mailman/listinfo/support
More information about the Support
mailing list