[DXLog.net - Support] Footswitch

[9A5K]

Hi Vlad.

It works here without any problem.
Usually, I made a mistake and forget about DTR Always ON setting at this
port where footswitch is connected.
If there will be a problem to start this, please send me your port
configuration screen, so I can check it here.

73,
Chris - 9A5K



On Mon, May 19, 2014 at 9:34 AM, Souzkabel <souzkabel at yandex.ru> wrote:

> Hello Chris !
>
> Thank you very much
>
>
>
> I tried to do the same
>
> I probably made ​​a mistake
>
> I will try again and again :)
>
>
>
>
>
> Vlad
>
> R9IR
>
>
>
> From: 9A5K [mailto:9a5k at 9a5k.com]
> Sent: Monday, May 19, 2014 2:05 PM
> To: SOUZKABEL
> Cc: support at dxlog.net
> Subject: Re: [DXLog.net - Support] Footswitch
>
>
>
> Hi Vlad..
>
> It is same as used with N1MM software..
>
> So, here it goes:
>
>
>
>
>
> Serial port footswitch information (using the 9 pin connector numbers)
>
>
> Connect a 10k resistor between pin 6 and pin 7. Set DTR, pin 4 to "Always
> On" and RTS, pin 7 to "Always Off". Connect the footswitch between pins 4
> and pin 6.
> The program action will be on footswitch closure. The footswitch wires can
> not be referenced or connected to ground.
>
>
>
> This is how I am using it too here. And works.
>
> Of course, you need PTT pin configure on some of the interfaces..
>
>
> 73,
>
> Chris - 9A5K
>
>
>
>
>
> On Mon, May 19, 2014 at 3:24 AM, SOUZKABEL <souzkabel at yandex.ru> wrote:
>
> Hello !
> Specify how to make the interface and the settings for connecting to the
> serial port footswitch. ?
> This feature is already working?
> My attempts were unsuccessful :(
>
> R9IR
> Vlad
> _______________________________________________
> Support mailing list
> Support at dxlog.net
> http://www.dxlog.net/mailman/listinfo/support
>
>
>
> _______________________________________________
> Support mailing list
> Support at dxlog.net
> http://www.dxlog.net/mailman/listinfo/support
>