[DXLog.net - Support] Footswitch

[Sergey Dvadnenko]

Hi everyone!
The same problem here also.

That's what I do, step by step:
1. Com5 -> Enable-> Radio1->(DTR-CW, RTS-PTT) -> Check - works
2. COM1 -> Enable-> --          -> (DTR -Always ON, RTS - Always OFF, Footswitch -None)
3. Connect footswitch thrue the homemade interface to com1...checking  and....NOTHING.

Sergey UA6AA




Hi Vlad.

It works here without any problem.
Usually, I made a mistake and forget about DTR Always ON setting at this
port where footswitch is connected.
If there will be a problem to start this, please send me your port
configuration screen, so I can check it here.

73,
Chris - 9A5K



On Mon, May 19, 2014 at 9:34 AM, Souzkabel <souzkabel at yandex.ru> wrote: >Hello Chris ! >>Thank you very much >>>>I tried to do the same >>I probably made ​​a mistake >>I will try again and again :) >>>Vlad >>R9IR >>Hi Vlad.. >>It is same as used with N1MM software.. >>So, here it goes: >>>>>>Serial port footswitch information (using the 9 pin connector numbers) >>>Connect a 10k resistor between pin 6 and pin 7. Set DTR, pin 4 to "Always >On" and RTS, pin 7 to "Always Off". Connect the footswitch between pins 4 >and pin 6. >The program action will be on footswitch closure. The footswitch wires can >not be referenced or connected to ground. >>>>This is how I am using it too here. And works. >>Of course, you need PTT pin configure on some of the interfaces.. >>>73, >>Chris - 9A5K >>On Mon, May 19, 2014 at 3:24 AM, SOUZKABEL <souzkabel at yandex.ru> wrote: >>Hello ! >Specify how to make the interface and the settings for connecting to the >serial port
 footswitch. ? >This feature is already working? >My attempts were unsuccessful :( >>R9IR >Vlad >_______________________________________________