[DXLog.net - Support] EA4TX steering

[9A5K]

Hi Marco.

Actually, I've tested this with EA4TX during June, and confirmed it's OK.
ARSVCOM should be set to listen on UDP port instead of TCP.
There is a setting for DXLog in it, a least for version I've received from
EA4TX.
Don't have it here on this PC, so can check it later during evening hours.

In meantime, can you check which ARSVCOM version is used at your side?

73,
Chris - 9A5K


On Fri, Sep 11, 2015 at 11:00 AM, Marco HB9CAT <hb9cat at thezollingers.org>
wrote:

> Chris,
>
> I'm currently testing (again) rotator control; I see we can now steer an
> EA4TX rotor based on a direct connection to the ARSVCOM software.
> I tried that:
> - ARSVCOM is listening on TCP port 6000
> - I can even telnet to it and it works
> - I've checked with Sniffer: DXlog actually sends the commands to UDP port
> 6000 (not TCP): UDP: 57095 -> 6000 : 1 packets (100 Bytes), 0.00% cleartext
> (0 of 0 Bytes)
> - it doesn't work
>
> Is DXlog in fact using UDP instead of TCP or am I doing something wrong?
>
> Marco HB9CAT
> _______________________________________________
> Support mailing list
> Support at dxlog.net
> http://www.dxlog.net/mailman/listinfo/support
>