[DXLog.net - Support] EA4TX steering
Marco HB9CAT
hb9cat at thezollingers.org
Fri Sep 11 11:18:32 CEST 2015
Using ARSVCOM V.6.3.1 I try upgrading now
Marco HB9CAT
On 11 September 2015, 9A5K <9a5k at 9a5k.com> wrote:
> Hi Marco.
>
> Actually, I've tested this with EA4TX during June, and confirmed it's OK.
> ARSVCOM should be set to listen on UDP port instead of TCP.
> There is a setting for DXLog in it, a least for version I've received from EA4TX.
> Don't have it here on this PC, so can check it later during evening hours.
>
> In meantime, can you check which ARSVCOM version is used at your side?
>
> 73,
> Chris - 9A5K
>
>
>
> On Fri, Sep 11, 2015 at 11:00 AM, Marco HB9CAT <<hb9cat at thezollingers.org>> wrote:
> > Chris,
> >
> > I'm currently testing (again) rotator control; I see we can now steer an EA4TX rotor based on a direct connection to the ARSVCOM software.
> > I tried that:
> > - ARSVCOM is listening on TCP port 6000
> > - I can even telnet to it and it works
> > - I've checked with Sniffer: DXlog actually sends the commands to UDP port 6000 (not TCP): UDP: 57095 -> 6000 : 1 packets (100 Bytes), 0.00% cleartext (0 of 0 Bytes)
> > - it doesn't work
> >
> > Is DXlog in fact using UDP instead of TCP or am I doing something wrong?
> > Marco HB9CAT
> > _______________________________________________
> > Support mailing list
> > <Support at dxlog.net>
> > <http://www.dxlog.net/mailman/listinfo/support>
>
More information about the Support
mailing list