[DXLog.net - Support] EA4TX steering

[Marco HB9CAT]

OK I upgraded to 6.5.1 and now have access to the DXlog-specific configuration, broadcasting to port 12040.
That works :-)

I still have issues steering antenna 2, I'll send another e-mail

Marco HB9CAT


Am 11. September 2015, hat Marco HB9CAT <hb9cat at thezollingers.org> geschrieben:
> Using ARSVCOM V.6.3.1 I try upgrading now
> Marco HB9CAT
> 
> 
> On 11 September 2015, 9A5K <<9a5k at 9a5k.com>> wrote:
> > Hi Marco.
> > 
> > Actually, I've tested this with EA4TX during June, and confirmed it's OK.
> > ARSVCOM should be set to listen on UDP port instead of TCP.
> > There is a setting for DXLog in it, a least for version I've received from EA4TX.
> > Don't have it here on this PC, so can check it later during evening hours.
> > 
> > In meantime, can you check which ARSVCOM version is used at your side?
> > 
> > 73,
> > Chris - 9A5K
> > 
> > 
> > 
> > On Fri, Sep 11, 2015 at 11:00 AM, Marco HB9CAT <<<hb9cat at thezollingers.org>>> wrote:
> > > Chris,
> > > 
> > > I'm currently testing (again) rotator control; I see we can now steer an EA4TX rotor based on a direct connection to the ARSVCOM software.
> > > I tried that:
> > > - ARSVCOM is listening on TCP port 6000
> > > - I can even telnet to it and it works
> > > - I've checked with Sniffer: DXlog actually sends the commands to UDP port 6000 (not TCP): UDP: 57095 -> 6000 : 1 packets (100 Bytes), 0.00% cleartext (0 of 0 Bytes)
> > > - it doesn't work
> > > 
> > > Is DXlog in fact using UDP instead of TCP or am I doing something wrong?
> > > Marco HB9CAT
> > > _______________________________________________
> > > Support mailing list
> > > <Support at dxlog.net>
> > > <<http://www.dxlog.net/mailman/listinfo/support>>
> > > 
> > _______________________________________________
> Support mailing list
> Support at dxlog.net
> <http://www.dxlog.net/mailman/listinfo/support>
>