[DXLog.net - Support] SO2R Dual Keyboard focus problem while in S&P

[Ken K6MR]

This problem also occurs with a single keyboard doing SO2R. It takes a few up/down arrows to get the cursor back in the right place. I'm careful to always Alt-W before moving the VFO.


Ken K6MR



________________________________
From: support-bounces at dxlog.net <support-bounces at dxlog.net> on behalf of SM5AJV <sm5ajv at qrq.se>
Sent: Tuesday, November 29, 2016 3:11 AM
To: DXLog.net Reflector
Subject: [DXLog.net - Support] SO2R Dual Keyboard focus problem while in S&P

Hi!

For a while I have noticed a strange behaviour when doing SO2R with two
keyboards.

At occasions the keyboard focus is not working, i.e. it is lost. During the
recent CQWW CW
I finally found out what's causing this.

I am using two keyboards, doing RUN on R1 and S&P on R2.
If I dupe check a call on R2 and move the VFO,  the call is wiped out (I
have check that tickbox in band map properties).
I usally (right or wrong?) push SPACE while dupe checking.
Now the keyboards will get out of sync. I.e. it is impossible to enter a
call on R1 keyboard.
The only way to reset this is to push ALT-W on R2. Then the keyboards are
in sync again.
Several callers on R1 got unanswered due to this.

If i un-check the WIPE check box in band map properties, the problem goes
away, but it's too annouying
to push ALT-W before entering the each S&P call.

The problem is symmetrical, i.e. RUN on R2 and S&P on R1 will show the same
problem.


73
Ingo SM5AJV
_______________________________________________
Support mailing list
Support at dxlog.net
http://www.dxlog.net/mailman/listinfo/support