[DXLog.net - Support] FTDX5000 and FT2000 CAT not working 2.3.9.0

9A5K 9a5k at 9a5k.com
Sun Sep 4 08:18:25 CEST 2016


Actually, it is working in hf mode.
We found a problem with transverter mode.
Radio doesn't accept freq commands in 44-46 mhz range.
If command is sent on 28 mhz band, radio goes in regular mode, transverter
mode goes off.
It doesn't work with HRD as well.

Waiting for response from yaesu team.

On Sep 4, 2016 02:48, "John Warburton" <qrz at dxdx.co.uk> wrote:

> Jim
>
> During IOTA at G2F I mentioned to you that typing the frequency on the
> DXLog logging line didn't always QSY the radio (K3 in that case).
>
> Sounds similar? I didn't realise at the time that it was connected with
> clicking on a cluster spot.
>
> 73 John G4IRN.
>
>
> On 02/09/2016 18:57, James Balls wrote:
>
>> Hi All
>>
>> Can anyone help .. FTDX5000 and FT2000 CAT
>>
>> DXL is receiving data from radios, tune VFO, and DXL follows
>>
>> If I clock a spot on band map or type in a freq on the log line and enter
>> the FT radios are not following.
>>
>> Works ok with HRD on same PC's cables, etc
>>
>> Something i've missed in setup ???
>>
>> Getting ready for 2m contest
>>
>> Jim M0CKE
>> _______________________________________________
>> Support mailing list
>> Support at dxlog.net
>> http://www.dxlog.net/mailman/listinfo/support
>>
>
> _______________________________________________
> Support mailing list
> Support at dxlog.net
> http://www.dxlog.net/mailman/listinfo/support
>


More information about the Support mailing list