[DXLog.net - Support] OTRSP device configuration

Luca Babolin ik2pfl at gmail.com
Sun Dec 17 21:36:16 CET 2017


Hello Chris,
I am trying to understand how the device configuration works for OTRSP 
devices.
The config table has 4 tabs (R1RX, R1TX, R2RX, R2TX), each row is a band 
and can configure AUX1..4 messages in the OTRSP protocol.
Using a serial monitor I recorded the messages sent by DxLog.
I set R1 on 15m, R2 on 10m and configured OTRSP as follows:
for R1RX (15m) AUX1=1 (bit1),
for R1TX (15m) AUX2=2 (bit6),
for R2RX (10m) AUX3=4 (bit11),
for R2TX (10m) AUX4=8 (bit16).

When I send the default alternate cq scenario1 (Advanced SO2R mode) I 
always and only see AUX1=1, AUX2=0, AUX3=0, AUX4=0 - regardless of any 
R1 or R2 state.
I see RX1, TX1, TX2, RX1S messages going out correctly from the serial.

I am using the sw latest version 2.3.15.
It looks the OTRSP config is only loaded once at the DxLog startup (or 
reload).

Any help or explanation/example would be appreciated.
Thanks
B. Regards
Luca IK2PFL



More information about the Support mailing list