[DXLog.net - Support] OTRSP output
John Warburton G4IRN
qrz at dxdx.co.uk
Fri May 26 12:06:49 CEST 2017
Just to close this one off:
I found that after defining the OTRSP configuration, a RELOAD was
required. That fixed it.
73 John G4IRN.
On 22/05/2017 08:04, 9A5K wrote:
> BTW, it depends on virtual serial port which is used.
> VU2PTT made lot of investigation about it and finalized correct config.
> We had some troubles with it @K1LZ, but after switching to VSPE
> software, it works ufb.
>
> 73 de
> EX/9A5K (on the way to JT5DX)
>
>
> On May 22, 2017 12:06, "James Balls" <makidoja at gmail.com
> <mailto:makidoja at gmail.com>> wrote:
>
> Hi John
>
> Worked fine with the yccc usb SO2R box
>
> If I remember with this we needed the software running for the
> SO2R box and configured the virtual ports for winkey, and switching
>
> Jim M0CKE
>
> On 21 May 2017, 21:26, at 21:26, John Warburton <qrz at dxdx.co.uk
> <mailto:qrz at dxdx.co.uk>> wrote:
> >
> >Hi
> >
> >I have an OTRSP device that works OK with Win-Test but it doesn't
> seem
> >to be working with DX Log. Has the OTRSP functionality been confirmed
> >as
> >working OK?
> >
> >The device is an SO2Rxlat - I should be seeing the on-board display
> >change values if it's working OK, but nothing happens. I've
> checked the
> >
> >COM port config - it's all the same as was set for WT.
> >
> >Any guidance would be appreciated please.
> >
> >73 John
> >
> >
> >_______________________________________________
> >Support mailing list
> >Support at dxlog.net <mailto:Support at dxlog.net>
> >http://www.dxlog.net/mailman/listinfo/support
> <http://www.dxlog.net/mailman/listinfo/support>
> _______________________________________________
> Support mailing list
> Support at dxlog.net <mailto:Support at dxlog.net>
> http://www.dxlog.net/mailman/listinfo/support
> <http://www.dxlog.net/mailman/listinfo/support>
>
>
More information about the Support
mailing list