[DXLog.net - Support] DX Doubler / Parallel port support

[Markku Oksanen]

Hi
OK, I have a couple of different inexpensive cards coming that are supposed work with N1MM.
If I have success, I will report on this.
BR
Markku

-----Original Message-----
From: support-bounces at dxlog.net [mailto:support-bounces at dxlog.net] On Behalf Of Kresimir Kovarik
Sent: Tuesday, December 18, 2018 11:56 AM
To: support
Subject: Re: [DXLog.net - Support] DX Doubler / Parallel port support

Hi Markku.

In options->configure interfaces screen, you can set any address for LPT
port you want/need.
Of course, dlportio or outport.dll should be used, to allow access to such
addresses.

Regarding PCI-express epp/ecp cards, I don't know, but if it is using same
way to access/set bits on particular
address range, it can work.

73,
Chris - 9A5K



On Sat, Dec 15, 2018 at 7:57 AM Markku Oksanen <markku.a.oksanen at kolumbus.fi>
wrote:

> Hi
>
>
>
> It looks like I may need to change PCs and the new one doesn't have a
> legacy
> Parallel Port.
>
> Does DXLog support the kind of bit by bit interfacing with parallel ports
> needed even if the parallel port is a PCI-EXPRESS EPP/ECP card/interface?
>
> Usually those cards specifically say that legacy parallel port addresses
> are
> not supported.
>
> Could DXLog allow for selecting the I/O address that the card actually
> uses?
>
>
>
> Thanks!
>
> Markku
>
> OH2RA/OG2A/WW1C
>
>
>
> _______________________________________________
> Support mailing list
> Support at dxlog.net
> http://www.dxlog.net/mailman/listinfo/support
>
_______________________________________________
Support mailing list
Support at dxlog.net
http://www.dxlog.net/mailman/listinfo/support