[DXLog.net - Support] K2 support

[9A5K]

Hi Dave.

I will check the difference between K3 and K2 in CAT protocol.
I suppose that we should add new radio in selection, to fix this.

73,
Chris - 9A5K



On Mon, Nov 25, 2013 at 11:42 AM, Dave Sergeant <dave at davesergeant.com>wrote:

> I used DXLog.net in this weekend's CQWW, by and large it worked well
> for my small single op station.
>
> The Elecraft K2 is not shown in the list of supported rigs, only the
> K3. It works OK selecting K3 but with a few problems associated with
> VFOA/VFOB switching as shown in the bandmap. This is because in the K2
> both VFOs are identical and fully interchangeable, whereas in the K3
> VFOA is the main VFO and VFOB is only used in split mode. When I select
> VFOB with my K2 I find VFOA wrongly shows the VFOA frequency...
>
> If I leave the rig field blank in the configuration settings (-) and
> use the same Elecraft/Kenwood settings (4800/8/N/2) the serial
> interface does not work at all for some reason. If I select the Kenwood
> setting it works but the VFOA display flickers between VFOA and VFOB
> frequencies so is even worse.
>
> Any chance of having the correct K2 settings in the interface?
>
> 73 Dave G3YMC
>
> http://www.davesergeant.com
>
> _______________________________________________
> Support mailing list
> Support at dxlog.net
> http://www.dxlog.net/mailman/listinfo/support
>