[DXLog.net - Support] Σχετ: Support Digest, Vol 4, Issue 10

9A5K 9a5k at 9a5k.com
Sun Sep 15 10:28:37 CEST 2013

Hi Nick.

I think that I know where is the problem.

DXLog.net in current version has IC-746 as possible selection in radio
But, actually, it is IC-746Pro.
There is a difference in default CI-V between these two radio.
IC-746Pro (and IC-7400) are using same default CI-V address which is $66.
Default CI-V address for IC-746 is $56.

I suppose you have IC-746 (not Pro version), and here is the problem.

In the new version, I've added new radio on the list (IC-746 Pro). And CI-V
for IC-746 is corrected to be $56.

Also, new version will bring possibility for user to change CI-V address
for ICOM radio in
the Config screen.

Stay tuned.

Chris - 9A5K

On Sat, Sep 14, 2013 at 9:08 AM, Νίκος Βαλμάς <sv1doo at yahoo.gr> wrote:

> Hi Chris.
> Tnx for replayed.
> I have the follow steps.
> Options-Configure interface. In the new window Printer port Enable-set
> up-click Band data - Active radio-cw and ptt and radio 1 then in previous
> window serial port (1 as i use) - Device Radio 1and click in setup.
> In the new window Radio icom 746 speed 19200-Bits 8-Parity N - stop 1-DTR
> and RTS i choose different choice foot switch None and  Active with Radio 1.
> Finally i switch off the program i show the follow warning.
> Unhandled exception has occured in your application.If you click continue
> the application will ignore this error and attempt to continue. If you
> click Quit the application will close immediately. Only True Type fonts are
> supported. This is not a True Type fonts.
> Many thanks to you Chris for you time.
> Vy 73
> sv1doo
> Nick

More information about the Support mailing list