[DXLog.net - Support] Microkeyer CW speed

[Frank - IZ4YDF]

Hi,
I have a microkeyer connected to PC running DXLOG v2.2.5.
Everything works fine except for the cw speed.
I haven't found out any option to control the cw speed via microkeyer
on-board potentiometer.
Is there any option/solution?
If I turn up or down the cw speed via dxlog (ALT+F9/F10) the interface
increase/decrease the speed to running via pc (F1-F2-F3-ecc...) but nor the
opposite situation works (change the pot. speed will not affect the
software speed).

Thanks in advance,
regards and 73

*Frank - IZ4YDF*