[DXLog.net - Support] Footswitch
9A5K
9a5k at 9a5k.com
Mon May 19 09:04:49 CEST 2014
Hi Vlad..
It is same as used with N1MM software..
So, here it goes:
Serial port footswitch information (using the 9 pin connector numbers)
Connect a 10k resistor between pin 6 and pin 7. Set DTR, pin 4 to "Always
On" and RTS, pin 7 to "Always Off". Connect the footswitch between pins 4
and pin 6.
The program action will be on footswitch closure. The footswitch wires can
not be referenced or connected to ground.
This is how I am using it too here. And works.
Of course, you need PTT pin configure on some of the interfaces..
73,
Chris - 9A5K
On Mon, May 19, 2014 at 3:24 AM, SOUZKABEL <souzkabel at yandex.ru> wrote:
> Hello !
> Specify how to make the interface and the settings for connecting to the
> serial port footswitch. ?
> This feature is already working?
> My attempts were unsuccessful :(
>
> R9IR
> Vlad
> _______________________________________________
> Support mailing list
> Support at dxlog.net
> http://www.dxlog.net/mailman/listinfo/support
>
More information about the Support
mailing list