[DXLog.net - Support] CAT PTT via Omnirig
Neil Powell
neilpowell1 at eircom.net
Wed Apr 22 16:46:57 CEST 2015
OK Great Chris,
I have bought the FT1000D home from the shack so will be able to test if need be.
Thanks very much as always.
Neil.
----- Original Message -----
From: 9A5K
To: Neil Powell
Cc: support at dxlog.net
Sent: Wednesday, April 22, 2015 3:18 PM
Subject: Re: [DXLog.net - Support] CAT PTT via Omnirig
Thanks Neil.
FT1000D cat is similar to 990 and it's different implementation then old one on FT-1000MP..
I have FT-990 here, so will check it as well.
Same for Omnirig.. more testing later today.
73,
Chris - 9A5K
On Wed, Apr 22, 2015 at 4:08 PM, Neil Powell <neilpowell1 at eircom.net> wrote:
Hi Chris,
A little information for you, I was in our shack and did some more testing with DXLog and setting up the Interlocking as this is a feature we would like to use, on the FT5000 connected directly via serial it works fine but when using PTT via CAT in Omnirig there is no PTT as before. On an FT1000D the CAT appears to be broken with no CAT communication with the radio (4800,8,N,2) even though the Microham MicroKeyer 2 is communicating ok (works OK in WinTest) , if I set the rig type to FT990 (which I believe is very similar) the frequency works OK but no PTT via CAT, but this might be because the command set is different in the 990 I am not sure. Also have an FT920 but this is not a supported Radio with DXLog so tested by using Omnirig and again no PTT via CAT with this also.
The Interlocking concept looks good but obviously with above issues have not managed to use it at all yet.
Thanks
Neil EI3JE.
----- Original Message -----
From: 9A5K
To: Neil Powell
Cc: support at dxlog.net
Sent: Monday, April 13, 2015 10:25 AM
Subject: Re: [DXLog.net - Support] CAT PTT via Omnirig
Hi Neil.
Let me check this at dev version.
If this feature is missing or broken, I will include the fix in next release.
73,
Chris - 9A5K
On Mon, Apr 13, 2015 at 11:24 AM, Neil Powell <neilpowell1 at eircom.net> wrote:
Hi Bob,
I have the lastest version and files for Omnirig installed and "pmTx" enable transmit mode and "pmRx" enable receive mode are in the config file for the radio but DXLog dosen't seem to be using them. I am hoping it can be sorted as want to use the Footswitch via the comport.
Neil EI3JE.
_______________________________________________
Support mailing list
Support at dxlog.net
http://www.dxlog.net/mailman/listinfo/support
More information about the Support
mailing list